NeoPixel Connectors / Connections

NeoPixel Connectors / Connections

Here are the NeoPixel / WS2812B light connectors that I've used. I hope this helps you find what you need for your next project!

*This post contains affiliate links. Learn more.

BTF-LIGHTING LED Strip Solderless DIY Connector Adapter

  • Connects strips together, or makes it easy to "bend" or put breaks in the strips.
  • No soldering required
  • Can have a slightly loose connection, so look for tension in the pins. 

HWELL LED Strip Lights Connectors 3pin - 10mm Solderless

  • Easy to connect to strips
  • Bare wires on one end make it easy to clip alligator clips, solder, or connect to your microcontroller in other ways

BTF-LIGHTING JST SM 3 Pin Connectors for WS2812B

  • Marries with the connector typically found on NeoPixel or WS2812B strips
  • Inexpensive
  • A bit hard to connect/disconnect, so not great for projects that require constant connection/disconnection

ALITOVE Core Male Female Plug LED Connector Waterproof IP65

  • Waterproof
  • Pre-tinned wires
  • Stable connection
  • Use for outdoor Bike Lights

Striveday 20 AWG 3 conductor wire (Red & Black & yellow)

  • Thick cable with strong exterior coating.
  • A little bit hard to bend, so not for close or tight connections
  • There is some powder inside the cable, Use a cloth to wipe off the powder when stripping the wires.

3 Pin PCB Mount Screw Terminal Block Connector

  • These terminal blocks make it easy to connect the LED strip connectors above to a breadboard.
  • Use a small screwdriver to trap the wires inside. 

3D printable neopixel strip corners:

Check it out here on Thingiverse.

Leave a comment

Please note, comments must be approved before they are published

We use cookies to improve your experience on our website. By browsing this website, you agree to our use of cookies. Accept